[pianotech] Keyslip photo 4

Terry Farrell mfarrel2 at tampabay.rr.com
Mon May 24 10:42:15 MDT 2010


Hi Rafael - Most likely you are correct that the keyslip is glued in  
place and was held there while the glued dried with the staples. I  
would sure like to see some other pictures of the piano - this thing  
appears that it may have been home-made - or at least the case was put  
on the piano in a non-factory setting. I ran across a similar piano  
not very long ago. I think the one I saw was some American  
manufacturer (Kimball maybe - I don't recall). The piano was not  
terribly old - maybe 10 to 30 years - and although the plate and back  
frame, etc. appeared to be factory - the case was CLEARLY not from a  
factory - and I mean the ENTIRE case. One of the things that really  
gave it away was the finish - it was applied with a brush (like so  
many garage-type jobs), but there was nowhere to be found ANY evidence  
of an "original" finish, nor any evidence that an original finish had  
been stripped off. There were parts that would normally have a finish  
that had no finish. And clearly the woodwork was sub-par (even for a  
Kimball).

Hard to tell from the two or three photos I saw, but the paint job,  
the staples, and a keybed made from particle board and plywood sure  
doesn't look like any factory-made piano I've ever seen.

I figured that perhaps in my case, someone - maybe a relative of  
someone who worked in the factory - or maybe a closed factory -  
somebody found a strung back and actions, etc. and built a case for it  
themselves.

Terry Farrell

On May 19, 2010, at 1:28 PM, Rafael M. Huberman Muñiz wrote:

> Jon, i pulled out one staple and it is vert small (2mm) i don't  
> think they are holding the keyslip... I Also tried banging out the  
> keyslip with a hammer and it didn't move at all... I beleive it is  
> glued...
> Rafael H
>
> Enviado desde mi iPhone
>
> El 19/05/2010, a las 11:32 a.m., Jon Page <jonpage at comcast.net>  
> escribió:
>
>>> No staples and no screws...
>>
>> On photos 3 & 4, look at the rectangular indents into the bottom
>> of the keybed a short distance back from the keyslip, staples.
>>
>> In photo 4 there are two staples embedded at the end with two
>> more spaced along the length.
>> -- 
>>
>> Regards,
>>
>> Jon Page

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100524/1826dba2/attachment.htm>


More information about the pianotech mailing list

This PTG archive page provided courtesy of Moy Piano Service, LLC