I saved Jon's email...here it is... David I. ----- This is a forwarded message ---------------------------------------- From: "Jon Page" <jonpage at comcast.net> To: ilvey at sbcglobal.net Received: 12/28/2008 1:28:01 PM Subject: Re: string measuring tool >Jon, > >I'm trying to find that attachment/photo, you sent some time ago. >The tool for measuring piano wire at the tuning pin during >stringing. I'd like to make one... David, Here it is. Position the Becket Tool differently along the hole according to the section of the piano. Treble wire is measured from the center while the Bass is measured from the back due to the slack/stretch of the longer wire in order to maintain consistent becket placement. Measure other sections incrementally, as illustrated above. The rear 'square' section is used for pin height. The pen mark and notch at the other end is for indexing pin already installed. Two of the photos were taken before the pen/notch upgrade. -- Regards, Jon Page -------------- next part -------------- A non-text attachment was scrubbed... Name: BecketTool.jpg Type: application/octet-stream Size: 852211 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091002/d8106353/attachment-0003.obj> -------------- next part -------------- A non-text attachment was scrubbed... Name: BktTool.jpg Type: application/octet-stream Size: 75316 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091002/d8106353/attachment-0004.obj> -------------- next part -------------- A non-text attachment was scrubbed... Name: BT1.jpg Type: application/octet-stream Size: 43828 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091002/d8106353/attachment-0005.obj>
This PTG archive page provided courtesy of Moy Piano Service, LLC