I should add that the action is slid out and in your lap as you lean over... David Ilvedson, RPT Pacifica, CA 94044 Original message From: KeyKat88 at aol.com To: pianotech at ptg.org Received: 2/25/2009 11:20:24 AM Subject: [pianotech] regulation tool : too wide Greetings, Going to make the adjustment of jack to knuckle, I find the neck/shank of the screw adjustor tool, too big in diameter to fit between the let-off buttons. The let-off buttons on this Young Chang grand are the dowel type. I've tried slipping the tool's shank from the bottom up, in-between the let-off dowels, but geesh, there's just no room! Is there a better tool for this? If so, who sells it? Julia Gottshall Reading, PA Get a jump start on your taxes. Find a tax professional in your neighborhood today. -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090225/fc30bd4f/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC