Gee, Ron, do I have to show you all my tricks? Since you can't (or shouldn't) have a steady flow of cutting oil on the drill bit, use your favorite 12 volt Black & Decker cordless drill with the almost dead battery and a dull bit and it will save your wrists! On the other hand, better to have a sore wrist than a broken bit.... Dave Davis, RPT ----- Original Message ---- From: Ron Nossaman <rnossaman at cox.net> To: Pianotech List <pianotech at ptg.org> Sent: Friday, March 2, 2007 12:24:04 PM Subject: Re: Pinblock/back separation repair > You mentioned that sometimes screws don't line up with backposts. I > don't have a problem drilling a hole in the plate so there *is* a bolt > going through all/most of the backposts. > > Dave Davis, RPT I have a problem with it. It's hard on the wrist when the drill breaks through the iron and grabs! Ron N -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070302/f2c57edb/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC