Hi Paul, Yes, Delignit. Steve Grattan, Associate Lost Chord Clinic ----- Original Message ----- From: "Paul Chick (Earthlink)" <tune4@earthlink.net> To: "Pianotech" <pianotech@ptg.org> Sent: Friday, July 23, 2004 8:43 AM Subject: RE: Delignet ? > > Subject: Re: Delignet ? > > > For the past 20 years I have been using an "I" drill bit (.272) , air > cooled. I use a pin driving fluid and get initial torque readings at 140 - > 160 inch pounds. After chipping and several tunings it settles down to > 110 - 130 inch pounds torque. No failures yet. > I do at least 10 pinblocks a year this way. > > Steve Grattan, Associate > Lost Chord Clinic > > Subject: Delignet ? > > > List members and pin block installers: > > > > What drill size do you like for a 2/0 pin when using Delignet for the > block? > > > > Paul C > > Thanks Steve. I like the torque readings you're getting. > > Paul C > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC