Just for the record, I don't think I posted any of the below messages. So, if they're wrong, don't blame me! :-) Avery At 11:49 PM 09/01/03 -0700, you wrote: >----- Original Message ----- >From: "Farrell" <mfarrel2@tampabay.rr.com> >To: "Pianotech" <pianotech@ptg.org> >Sent: September 01, 2003 4:22 PM >Subject: Re: Function of the rim > > > > Yes, that is likely the best answer of the four, but it think the real >reason is to have the pin at a very slightly acute angle to the string so >that a tight coil in maintained. > > > > Terry Farrell > > > > ----- Original Message ----- > > From: "Avery Todd" <avery@ev1.net> > > To: "Pianotech" <pianotech@ptg.org> > > Sent: Monday, September 01, 2003 4:58 PM > > Subject: Re: Function of the rim > > > > > >Here's another head-scratcher. I didn't find any other clinkers. > > > > > > > >75) The tuning pin hole is drilled at a slight angle to the pinblock > > > >primarily in order to > > > > > > > > A. create an orderly row of pins > > > > B. resist the pull of the string under tension > > > > C. create a better lock of the pinblock to plate flange angle > > > > D. satisfy tradition > > > > > > > >In their answer key, the right answer is >.......................................... C > > > > > >I would take exception to all but D. I've never had a satisfactory answer >to this question from anyone at any of the factories that employ the >practice. Finally, after making up a sample and a drawing it came to me. My >answer was published in the Journal some time back. Basically, the >pinblocks in certain pianos using three-ply pinblocks and with plates >covering the blocks which were drilled and pinned without any kind of >bushing surrounding the pin had a tendency to split. By using a relatively >small hole bored vertically in the plate with a pin angled back >sufficiently it was possible to let the pin rest against the plate at the >bottom of the hole while looking nicely centered at the top. > >If you don't believe me, do the math, make the sample and draw the picture. >As to the idea that it helps keep a tight coil...well, look at the angles >involved. It does exactly the opposite. Or look it up in the Journal. When >pianos using this system are tuned the strings walk down the pin actually >spreading the coils. > >Del > > >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC