At 08:08 AM 02/26/03 -0800, you wrote: >So, then, would the ideal drilling/pinning technique >be Denro pins in a Delignit ( Or Farrelwood )block, Farrelwood??????? Sorry, the devil made me do it! :-) Avery >drilled with the two bit method and spot chilled? But >turned in, or driven with air hammer? And what is this >two-bit method again, if you don't mind? > Thump > >--- Ron Nossaman <RNossaman@cox.net> wrote: > > > > >FWIW, I have used the Diamond. I bought them > > BECAUSE they were more > > >expensive (the standard theory being that I will > > screw up enough, might as > > >well use the best materials - that might make up > > for some of my work). Not > > >knowing which pins where like what, I was just > > hoping they were a little > > >bit better in some way. I found that they varied in > > diameter over a few
This PTG archive page provided courtesy of Moy Piano Service, LLC