>All, >A while back I was espousing the quality of the Schaff Bridge pins. The >standard size for #8 bridge pins is .096". The olde ones I used to get from >Tuners were .0955". That little difference, I can deal with. The New ones >from Schaff are .0945"! If I were doing a new bridge, I could still deal >with the difference. But, on a re-pin of an existing bridge, that just don't >cut it!!!!! I just spent the better part of a day, dealing with it! Darn! I >Wish They'd Get It Right! Or, at least tell us about it! >End of Rant!<G> >Best Regards, >Joe Garrett, RPT, (Oregon) Hi Joe, A couple of questions. What did the take-outs mic? Did you epoxy the replacements when you installed them? Has anyone out there tried steaming a bridge cap lightly to size holes down (like happens in key balance holes) before installing pins with epoxy or CA? Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC