Of course, you are right. Man ! these measurements need such an accuracy ! I begin to see the light about friction issues. Stéphane. ----- Original Message ----- From: "David C. Stanwood" <Stanwood@tiac.net> To: "Pianotech" <pianotech@ptg.org> Sent: Saturday, November 02, 2002 9:16 PM Subject: Re: action ratios | Stéphane, | | Don't use a blade to rest the flange on, use a roller bearing, otherwise | you will get inconsistent results.. | | David S. | | At 09:13 PM 11/2/02 +0100, you wrote: | ... | >So if you are still interested, here are my corrected measures of SW (as I | don't have the Stanwood tools yet, I did the SW measure holding the hammer | shank on a blade just beneath the center pin, so the hammer shank is | horizontal. My previous measures were with the blade under the knuckle. | My fault.) | >...Stéphane Collin. | | | | _______________________________________________ | pianotech list info: https://www.moypiano.com/resources/#archives |
This PTG archive page provided courtesy of Moy Piano Service, LLC