Stéphane, Don't use a blade to rest the flange on, use a roller bearing, otherwise you will get inconsistent results.. David S. At 09:13 PM 11/2/02 +0100, you wrote: ... >So if you are still interested, here are my corrected measures of SW (as I don't have the Stanwood tools yet, I did the SW measure holding the hammer shank on a blade just beneath the center pin, so the hammer shank is horizontal. My previous measures were with the blade under the knuckle. My fault.) >...Stéphane Collin.
This PTG archive page provided courtesy of Moy Piano Service, LLC