Fw: Plate Lettering

[JIMRPT@AOL.COM]

In a message dated 4/21/2001 2:38:01 PM, you wrote:

<< Wish there was a

simpler way that takes less time and looks as good but I haven't discovered

it.>>

Dale;
 I use a Sanford "Sharpie" with an 'ultra fine point'. After the 'first' coat 
of clear I apply the serial No. with rub-off numbers and 'carefully' hand 
number the sizes. I then apply however many coats of clear that I want to 
use. This leaves all numbers with a glossy look which matches plate gloss. 
Total time.....about ten minutes.
My way.
Jim Bryant (FL)