jptuner wrote: > > hello all, > I have been wondering when spraying plates with spray paint, > can the oils from the paint effect the pin block,of course when i > restring i always spray the plate to make it look good, the plate does > not come out ,these are restringing jobs in homes or my shop, i have > restrung close to a 100 or so pianos and have not had a problem yet.But > does it or could it effect the pin block.PS I have never used a clear > coat on the finish, but my results are very pleasing,i will try the > clear on my next job. > jptuner! jptuner, The only time it is a problem is if you spray while the tuning pins are out of the holes. Then it makes the tuning pins jumpy! If you are going to put in new pins, clean up the web area then put the pins back in with a little tap to make them snug but still removable. Take them out before the last spray coat dries(carefully), so you won't chip the finish if you goof. Hope this helps. Warren -- Warren D. Fisher fish@communique.net Registered Piano Technician Piano Technicians Guild New Orleans Chapter 701
This PTG archive page provided courtesy of Moy Piano Service, LLC