strings cannot be tuned!

[RPSPIANO@aol.com]

In a message dated 97-01-17 10:21:44 EST, you write:

<< Look VERY closely at the becket. The bend in
 the wire should be very close to the hole and a reasonably sharp bend. If
 it looks like it's elongating, especially if the problem notes are only the
 strings which have been replaced, it is very possible that the strings are
 slipping out of the tuning pin hole very gradually. >>

Good point, also make sure the end of the becket is through the
entire length of the tuning pin hole and was not left too short.

mark Ritchie