[CAUT] PVC-E glue

[Cy Shuster]

I heard a good workaround for this problem: use a razorblade to scrape a 
little grit from a piece of sandpaper onto the wet glue before applying the 
keytop.  A dozen grains will do the trick.

--Cy Shuster--
Bluefield, WV

----- Original Message ----- 
From: "Ken Zahringer" <ZahringerK@missouri.edu>
To: "College and University Technicians" <caut@ptg.org>
Sent: Tuesday, April 12, 2005 12:16 PM
Subject: Re: [CAUT] PVC-E glue


> The only problem I have experienced is perhaps too much "wiggle room".
> If you apply too much glue, the keytop can slide around a fair bit when
> you clamp it.