Titebond Trim and Molding glue for bushings....

[Prof. Euphonious Thump]

I saw the "sandable" and "fills small gaps"
description on the bottle,  tried some on some test
bushings, and truly liked the way it handled ! 
Held the felt fast, but still softened under water,
dried harder than PVC or regular PVBA ( meaning less
sweling in humidity, I suspect ).
     Unless someone gives me a  good reason not to, I
intend to use this stuff on keybushungs ( and
soundboard shims ) henceforth.
     G

 







m
--- Jon Page <jonpage at comcast.net> wrote:

> >What do you use to get such a good, clean cut at
> the
> >top when you're finished? Razor blade or what?
> 
> A razor blade cut through the veneer and cloth
> against the brass caul.
> 
> For the bushing on the left, that was a Bushmaster
> install. I cut from the
> center out with a razor blade once the cauls are
> removed and then sand
> the buttons with a palm sander and 180 grit paper.
> -- 
> 
> Regards,
> 
> Jon Page



      ____________________________________________________________________________________
Looking for last minute shopping deals?  
Find them fast with Yahoo! Search.  http://tools.search.yahoo.com/newsearch/category.php?category=shopping