On 8/21/2012 7:37 AM, Jim Ialeggio wrote: > Ron said: > > <So does spinning your spot facer in the counter bore to clean it out > > What's a spot facer? an endmill? A piloted counter bore, used for making a fastener head bedding surface perpendicular to a hole that is not perpendicular to the surface. Google it. http://www.yardstore.com/browse.cfm/2,410.html http://www.iowa-industrial.com/Eastern-Iowa-/Construction-Equiptment-/One-hss-spot-facer-1-5-16-diameter.cfm Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC