One does not need another person if one makes the coil on a spare tuning pin, before slipping it over the real pin for tightening and coil dressing. -- Mark Schecter On Oct 24, 2011, at 4:52 PM, "Joe Goss" <imatunr at srvinet.com> wrote: > Yes There is. But it does not always something that a single person can do. One needs a third hand to pull the string tight as the other person is tightening the tuning pin and watching where the wire is going. > I use a screw driver to help start the Beckett and then tighten the string . Or make the becket with a round shoulder / flat jaw pliers > Joe Goss BSMusEd MMusEd RPT > imatunr at srvinet.com > www.mothergoosetools.com > ----- Original Message ----- From: <atrav27 at att.net> > To: <pianotech at ptg.org> > Sent: Monday, October 24, 2011 3:56 PM > Subject: [pianotech] Replacing strings and coil lifters > > >> Too often when replacing a single string there's not enough room for my coil lifter to work properly, so I have a dental pick with a hook on the end that helps, and a mini-flat blade screw driver with the blade bent in a L. But, that slows the whole process down and makes me think there has to be a better way. Are there any other crafty ways to lift a coil while tightening a single string? >> >> TIA, >> -A- > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC