[pianotech] Bridge cap epoxy

[Rob McCall]

Am I to assume we're talking about added heat over and above what the epoxy produces all on it's own?

I like the West system.  It doesn't get any easier than that for me. :-)

Regards,

Rob McCall

McCall Piano Service, LLC
www.mccallpiano.com
Murrieta, CA
951-698-1875

On Nov 29, 2011, at 11:16 , Delwin D Fandrich wrote:

> Heat will also weaken epoxy. Use a thin coating epoxy such as that made by System Three.
>  
> ddf
>  
> Delwin D Fandrich
> Piano Design & Fabrication
> 6939 Foothill Court SW, Olympia, Washington 98512 USA
> Phone  360.515.0119 — Cell  360.388.6525
> del at fandrichpiano.com — ddfandrich at gmail.com
>  
> From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of John Ross
> Sent: Tuesday, November 29, 2011 8:20 AM
> To: pianotech at ptg.org
> Subject: Re: [pianotech] Bridge cap epoxy
>  
> Heat will thin epoxy, so that it penetrates.
> John Ross
> Windsor, Nova Scotia
> On 29-11-2011, at 5:49 AM, Joe Wiencek wrote:
> 
> 
> Hello list,
> I've been reading with great interest about the recent articles in the Journal about treating  bridges with thin epoxy. I am trying to imagine an epoxy that's thin enough to be put on the bridge cap without it adding material. Is there a very thin viscosity epoxy on the market that's being used for this, or the possibility of thinning epoxy with lacquer thinner or some other solvent? 
> Thanks for any input. 
> 
> Joe Wiencek
>  

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20111129/6f7a7ea4/attachment.htm>