I can’t think of one. The bearing focusing the fulcrum at the apex of the bearing so shimming the one side of the balance rail doesn’t seem like it will work. David Love www.davidlovepianos.com From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Jerry Cohen Sent: Monday, June 27, 2011 11:17 AM To: pianotech at ptg.org; ptg_touchweightne at egroups.ptg.org Subject: Re: [pianotech] Touchweight: Re: half punching & figuring FW David, On "regular" accelerated actions with the bearings, is there any way to apply the veneer strip to change the key ratio? Thanks, Jerry Cohen, RPT NJ Chapter _____ From: David Love <davidlovepianos at comcast.net> To: pianotech at ptg.org; ptg_touchweightne at egroups.ptg.org Sent: Monday, June 27, 2011 1:53 PM Subject: Re: [pianotech] Touchweight: Re: half punching & figuring FW Interesting isn’t it, it’s an “accelerated action” (or so it’s stamped on the action frame) without the bearings. No I didn’t remove them. Key lead positions are consistent with the accelerated actions. David Love www.davidlovepianos.com -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20110627/8a6b9f0a/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC