Mike Spalding wrote: > Ron, > > OK, that fits with what I've experienced. My second pass drill is a > conventional F jobbers bit, but I want to use a brad point for first > pass; it's easier to align with the transfer punch marks. I'll look for > a 6mm brad point. Or a B, or even C. Fullers has them. http://www.wlfuller.com/html/regular_length_brad.html >I believe you've commented in the past that your > second pass drill bit has been in use for many blocks, dulling does not > seem to be an issue. It doesn't seem to be, probably because it's just a reaming pass. >Did you find that initial sharpness of the new bit > was detrimental - is there any advantage to dulling the tip of a new bit? It was too long ago for me, but others have reported no problem with new bits. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC