View full size HEY Will Here is a different idea about the hoses. Each hose has a brass fitting with a small valve so I can open & close each valve as I am ready to inflate. The entire inflated system is attached to the air supply so no leak down....unless of course the compressor fails or the power goes off. Well if I tighten everything with a wrench then no worries...otherwise I don't' worry about loosing some air. Dale Hi List, Since I didn't like to have attached hoses to keep pressure in the clamping hoses, I used a standard cap that I drilled to accept truck tire valves. The store assured me that these valves were good for 150 psi. So I just fill the hose ahd then I can walk around the board without jumping over or crawling under the air hoses. I've attached a pic. Marcel Carey Utilisez Windows Live Messenger pour envoyer des messages sur les cellulaires de vos amis Plus de détails sur notre site PC at cellulaire = [Image Removed] -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080928/4fa5c871/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC