Ron: I've been tapering all my hammers on a table saw for 20 plus years and have never had a hammer explode. Am I just lucky? What am I missing here? Will Truitt P. S. I took a bunch of pictures of my hammer tapering jig for mounted hammers today in the shop. As soon as I can figure out the protocol of mailing them to the forum, I will send them - hopefully tonight. -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Ron Nossaman Sent: Tuesday, September 09, 2008 12:58 PM To: Pianotech List Subject: Re: reducing hammer weight > Good point and I might have, but most of the hammers in this set needed > to have mass added to them, and my table saw setup isn't really as > accurate as the sanding for removing smaller amounts of material. But if > the whole set needed reducing by a gram then absolutely the saw will get > you there faster better cheaper! > > - Mark Dierauf Until you hit a staple and explode a hammer, for which you have no replacement. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC