> To ream or not to ream, that is the question. > > I seem to recall from the initial post that there were two sizes > of pins in this block. Correct, which precludes ignoring the reaming pass. > In that case you would have to determine the appropriate > drill bit to use to suit your new pins. > > I would also encourage you to look into Ron's two-bit method. The first pass hole's already there. This would be pass two. > If 2/0 were in there and were comfortably secure, I'd go with > 3/0 throughout and ream accordingly to the density of the block. A reasonable approach. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC