Hi Terry: This is ever so slightly off topic at hand, but I'll run with it anyway. I'm going to be using the 3/8" x 16 thread x 4" long socket set screws for plate screws as you, Ron, Del, and others are doing. What size drill bit are you using to drill the hole in the rim? (or drill the plugs glued in the holes, as it were). Are you tapping afterwards? What size tap if so? I was able to get these screws, acorn nuts, etc at my local Fastenal. One inch round brass stock as well for mass loading. I mention this for others, as there are supposedly 4000 of these stores in the U. S., so you may just be able to run down the street instead of mail ordering. Lots of other stuff there that us weird piano rebuilders might use or adapt, and they have a huge catalog. Also, these 3/8" screws miked out at .369 instead of the .375 that 3/8" works out to. Does that differ from your stock? Thanks for your help! Will Truitt By the way, I think this set up is absolutely brilliant in its simplicity and application. Kudos to Del and Ron for coming up with it. From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Farrell Sent: Wednesday, June 18, 2008 4:13 AM To: Pianotech List Subject: Re: Machine Threads in Pinblock, was WD-40 Hi Ron! I also use coarse thread as you do. However, I have tried tapping the maple and found that it made the hole too big - I used the proper tap for the given machine screw. I figured that the maple must have enough give in it (compared to metal), that caused the poor fit. I've gone to simply drilling a hole a little smaller than the thread and simply running a buttered (wax) machine screw into the hole (just like one does with a wood screw). I seem to get the nice tight fit that way. Do you find that you machine screw have a snug fit after tapping the hole? Terry Farrell ----- Original Message ----- From: Ron Overs <mailto:sec at overspianos.com.au> To: Pianotech List <mailto:pianotech at ptg.org> Sent: Tuesday, June 17, 2008 4:48 PM Subject: Re: Machine Threads in Pinblock, was WD-40 Fenton, . . . Would you recommend a fine or coarse thread? Always course threads in wood. We use the regular tapping tools after drilling the minor diameter. Ron O. -- OVERS PIANOS - SYDNEY Grand Piano Manufacturers _______________________ Web http://overspianos.com.au mailto:ron at overspianos.com.au _______________________ -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080618/d8a4a671/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC