If you have a router table setup, you can use a very small ' flush cut ' router bit. In the end you only need to clean up the notches with a file. I'm sure there are other ways too that I would like to hear about. Dave ----- Original Message ----- From: To: pianotech at ptg.org Sent: 5/19/2007 5:21:02 AM Subject: keytops List, Just completed a set for a Lester console. What is the preferred method of removing overhang of keytop on sides? I usually use a file and sometimes a drum sander, but I'm looking for something more precise . Also, I noticed many fine scratches and imperfections in this set. I was very careful with them and I don't think I was the culprit.Anyone else seen the same? Schaff supplied. Thanks Rick Ucci/Ucci Piano -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070519/7209d4e1/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC