Many times if just a few pins are loose you can apply the CA to the joint where the top of the plate meets the pinblock. The CA will run down the face of the block behind the plate. You can see it wick into the bushings if it is so equipped. Don't over do it or it will run out of the hole where the pressure bar screws go through the plate. Randy Mangus Mangus Piano Service 140 Atkinson Ave. Wheeling, WV 26003 ************************************** Get a sneak peak of the all-new AOL at http://discover.aol.com/memed/aolcom30tour -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070715/3331c684/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC