Accu-just System

[Ron Nossaman]

> I am restringing a Baldwin R. I do have the Baldwin Technical specs on 
> Downbearing. The restringing procedure mentions setting down bearing. 
> This is where I would like to know what tool is best to raise or lower 
> the strings according to the specs.
> 
> Jack Houweling


A mild steel rod with a hole big enough to go over the hitch pin, 
and a small hammer works well for lowering. A coil lifter, sitting 
on a piece of wood or hard leather to protect the plate, works well 
(enough) for prying them up.

Ron N