Britt, I've never known of any kind of spring that used a wire gauge as heavy as any piano wire! WAY too heavy! Am I missing something? Avery At 06:43 PM 11/22/05, you wrote: >Mike, > I usually use a spring making jig and make them out of piano wire. >Piano wire is, I believe, spring steel. I think I got the jig from >Schaff though it could have been APSCO it was several years ago. >Measure the diameter of the wire and make sure that you have some >piano wire is the same or close. If not Schaff sells a variety of >sizes used for other purposes besides stringing pianos. You could >also make a jig to bend the wire around. Email me privately if you >like and I will send you a photo of the jig I have. > >Britt > > >Britt West, RPT > >West Piano Service >2211 Flat Rock Road >Watkinsville, GA 30677 >706-769-4060 >706-338-9557 > >registered piano technician >Piano Technicians Guild >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC