Polishing White Plastic Key-tops

[Terry]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
I just hit 'em with the buffing wheel. Never really worried about what =
compound I used. They come out looking like new. It only takes a second =
or two. I'd be leary of using the dremel - use a buffing wheel that can =
cover the entire key width. You can remove a pretty deep gouge in just a =
few seconds. Go with a slow speed. Don't do it too much because you can =
melt the plastic pretty quick.

Terry Farrell
  ----- Original Message -----=20
  From: Michael Gamble=20
  To: pianotech@ptg.org=20
  Sent: Wednesday, January 12, 2005 4:01 PM
  Subject: Polishing White Plastic Key-tops


  Hello list
  I don't know if this subject has been covered. A client has this Yam =
U1 which suffered a broken key-top. The broken part successfully glued =
in place but the whole area needs repolishing.The surface is lightly =
scratched - enough to visibly and tactilely make one aware that all is =
not what it ought to be. Any ideas on this? Dremel buffing mop? Any =
special gunge required?=20
  Regards from across the Pond
  Michael G (UK)
---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/c9/58/58/77/attachment.htm

---------------------- multipart/alternative attachment--