Dear Carl, Thanks for the reply. I already have a Fordham tool, with all the bells and whistles. Is there anyway that you would sell the McCall separately? I await your response. Thanks again, Spencer Brewer 707-621-0493 > From: "Carl Meyer" <cmpiano@comcast.net> > Reply-To: Pianotech <pianotech@ptg.org> > Date: Mon, 5 Dec 2005 18:49:16 -0800 > To: "Pianotech" <pianotech@ptg.org> > Subject: Re: McCall mini disc sander > > > I put about 400 dollars into a McCall mini belt sander including a special > bi directional Foredom motor and flexible shaft. Also have the speed > control. In order for the belt to track the pulleys need to be crowned and > these were not. I never did use it. Couldn't get the belt to track in both > directions. I considered modifying the pulleys but instead developed the > turkey slicer model. Yes, it will sand hammers w/o removing anything but > the action. > > Happy to take 250 dollars for all. > > Carl Meyer PTG assoc > Santa Clara, Ca. > > > ----- Original Message ----- > From: "Spencer Brewer" <sbrewer@pacific.net> > To: <pianotech@ptg.org> > Sent: Monday, December 05, 2005 12:53 PM > Subject: McCall mini disc sander > > >> I am looking for a McCall mini-belt sander that is used for reshaping >> hammers. I don't think they are being made anymore, but if someone has one >> or knows where I can find one...that would be great. >> >> Thanks, >> >> Spencer >> sbrewer@pacific.net >> >> _______________________________________________ >> pianotech list info: https://www.moypiano.com/resources/#archives >> > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC