It doesn't. The issue here is not maintaining the strike point. When the hammer flattens out it strikes the strings on each side of the flattened surface. Since lacquer is usually applied from the shoulders, the outer edges of the shoulder can be a bit crusty and you can end up with two rather pingy strike points. David Love davidlovepianos@comcast.net -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of Jerry Cohen Sent: Wednesday, September 29, 2004 6:16 AM To: 'Pianotech' Subject: RE: Evidence of overlacquered hammers Getting back to the original subject, why would over lacquering cause the hammer to strike the string at 2 different points? Did I misinterpret something? Thanks. Jerry Cohen NJ Chapter _______________________________________________ pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC