Good: West System 2-step wet-out epoxy repair prodedure. Better: West System 2-step wet-out epoxy repair prodedure plus new veneers. Best: Replace lid. Terry Farrell ----- Original Message ----- From: "Bob Hull" <hullfam5@yahoo.com> To: "Pianotech" <pianotech@ptg.org> Sent: Thursday, October 28, 2004 11:54 AM Subject: Re: Cracked Lid > Along the same line, I have a customer with an antique > grand (Erard) about 8', and the lid is cracked > lengthwise down the middle. Before anything can be > done, including tuning, repair of the lid needs to > take place because it may split completely if put up > on a stick. > > I'm trying to decide how to proceed. > > Bob Hull > > > ----- Original Message ----- > > From: "James Grebe" <pianoman@accessus.net> > > To: "Pianotech" <pianotech@ptg.org> > > Sent: Thursday, October 28, 2004 7:47 AM > > Subject: Re: Cracked Lid > > > > > > > On long grands where the lid has been kept mostly > > in the up position you > > can > > > imagine the stress, over the years it put on the > > glue joints on the long > > > core panels glued together for the lid with only > > support on one end and > > the > > > other just kind of hanging out there. It is a > > wonder that we do not seem > > > more of this in anything over 6'. I do not know > > if they used any special > > > types of joint between the boards or if they were > > all just edge glued. > > Any > > > one tore one apart to see.? > > > Jim > > > > > > James Grebe > > > Piano-Forte Tuning & Repair > > > Creator of Handsome Hardwood Caster Cups > > > (314) 608-4137 > > > WWW.JamesGrebe.com > > > 1526 Raspberry Lane > > > Arnold, MO 63010 > > > BECOME WHAT YOU BELIEVE! > > > pianoman@accessus.net > > > ----- Original Message ----- > > > From: "Paul Chick (Earthlink)" > > <tune4@earthlink.net> > > > To: "Pianotech@Ptg.Org" <pianotech@ptg.org> > > > Sent: Wednesday, October 27, 2004 7:05 PM > > > Subject: Cracked Lid > > > > > > > > > > List readers: > > > > > > > > I inspected a recently refinished mahogany > > veneered lid for a 1901 > > > > Steinway > > > > Grand that is showing cracks through the finish > > telegraphed from the > > > > joints > > > > of the core material. There doesn't appear to > > be any cross banding > > > > between > > > > the core-which looks like oak-and the face > > veneer. The cracks are from > > > > the > > > > hinge end and show on both sides of the lid. > > The shop is a first rate > > > > refinishing facility with very talented staff. > > No one hs ever seen this > > > > problem before, and no one remembers seeing the > > cracks in the lid before > > > > refinishing. The stripping process does not use > > waterbased strippers or > > > > rinses. The humidity during stripping and > > finishing was close to 60%, > > now > > > > it's about 40%. Has anyone seen this in other > > lids/pieces from that era? > > > > I'd > > > > appreciate any thoughts or experiences. > > > > > > > > Thanks > > > > > > > > Paul C > > > > > > > > _______________________________________________ > > > > pianotech list info: > > https://www.moypiano.com/resources/#archives > > > > > > > > > > > > > _______________________________________________ > > > pianotech list info: > > https://www.moypiano.com/resources/#archives > > > > > > > > > _______________________________________________ > > pianotech list info: > > https://www.moypiano.com/resources/#archives > > > > > > > __________________________________ > Do you Yahoo!? > Take Yahoo! Mail with you! Get it on your mobile phone. > http://mobile.yahoo.com/maildemo > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC