MINE, <g> Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "J Patrick Draine" <draine@comcast.net> To: "Pianotech" <pianotech@ptg.org> Sent: Thursday, October 07, 2004 11:42 AM Subject: screw holders > What are the rest of you doing for screw holders? The Schaff "rigid > shaft screwholder" (#874) is next to useless for removing/replacing > hammer flanges screws in vertical piano actions. My old ones which > looks the same, from Apsco or Tuners Supply, worked fine, but I lost > them (on some customer's floor no doubt). The current (unless they > redesigned since I complained to a staffer at Nashville) Schaff version > doesn't open wide enough to release the screw properly. Anyone buy one > recently that is acceptable? > How about other models at other suppliers that you're satisfied with?? > Patrick Draine > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC