You can found little abrasive rubber wheels that are used in Jewelry. In a Dremel tool they allow to clean and burnish at the same time any rough metal part (or wood for that matter) Not really expensive if you find a professional supplier for jewelers - select different sort and make experiments, I have some yellow ones and white for the thinnest work, gray or brown are more aggressive. They hold relatively well in time. And I bought lately a suspended flex from Dremel, not so expensive and not so professional, but it will do the trick I hope. Isaac OLEG > -----Message d'origine----- > De : pianotech-bounces@ptg.org > [mailto:pianotech-bounces@ptg.org]De la > part de Michael Gamble > Envoyé : dimanche 7 mars 2004 09:14 > À : Pianotech > Objet : Re: Damper lever felts, dents in > > > Hello List and Richard M who said: > "some of the damper lever felts are so indented from the pressure > of the damper spoon that that dent catches the spoon upon > return and won't > allow the wip to return all the way. Some others do return > but much slower > than with the damper pedal depressed." > This is really an old problem with an old upright piano. > The ony reason I > have found for such aggravated deressions in the damper > tail felt is the > spoons themselves. They must be burnished. I'll bet you > find thos spoons all > rough! I usually use a very, very fine emery pad on the > spoons and, while > I'm at it, apply the same procedure to the damper lift rod. I have > frequently found the tail pads worn right through to the > wood! They then > catch on the spoon and the lever hangs in there. This is > common enough for > me to apply the "manual pull back" on any suspect damper if > this condition > is suspected. Changing the tail cloths is also required. > Regards from a sun-drenched early Sunday in the Sussex Downs > Michael G (UK) > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC