That's what I've been using also. Seems to work quite well. Terry Farrell ----- Original Message ----- From: "Paul Chick (Earthlink)" <tune4@earthlink.net> To: "Pianotech" <pianotech@ptg.org> Sent: Friday, June 18, 2004 11:27 PM Subject: RE: Bridge over troubled waters > > Subject: RE: Bridge over troubled waters > > > > >What size drill do you use for #7, #8, #9, #10 bridge pin? > > > >Paul C > > I don't have any disagreement with Pianotek's recommendations. > > #46 (0.0810) for #7 (0.086) > #42 (0.0935) for #8 (0.096) > #36 (0.1065) for #9 (0.109) > #30 (0.1285) for #10 (0.135) > > > Ron N > > Thanks Ron. I looked at their bit sizes and wondered if they might be a > little too tight; will try them. > > Paul C > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC