This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment >>Poured a bunch of West System epoxy into the voids. ! I usually drill = downward into the cracks with a 1/8" drill every inch or two to make a = channel for the epoxy to get down into the bottom of the crack... =20 =20 Put your epoxy into a syringe (available at farm supply stores) and get = a drill bit the same size as the end of the syringe (leave needle off). = Then start your hole about ? inch from crack at about a 60 deg angle = down, so that the bit comes out into the crack about an inch below the = top. Inject your epoxy into this hole and it you can watch it fill the = crack from the bottom up. You'll need to drill holes about every 3-4 = inches. Dean =20 Dean May cell 812.239.3359 PianoRebuilders.com 812.235.5272 Terre Haute IN 47802 =20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/e1/40/03/9f/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC