This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Paul C asked: "List members and pin block installers: What drill size do you like for a 2/0 pin when using Delignet for the = block?" Paul C, I've used Delignet for most of my career. I usually use a 6.8mm drill = bit. However, there are varying grades of Delignet and sometimes an "H" = drill or a 6.9mm. I always do several test drill holes in the scrap. I = should also say, I always use pin driving fluid, so that will make a = difference in the size hole to be drilled. (Pin driving fluid makes a = tight hole somewhat looser.) If you do not have my Stats Chart, let me know and I'll send you one. Best Regards, Joe Garrett, R.P.T. Captain, Tool Police Squares R I ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/86/38/97/21/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC