Vacuum. Bag or table. Tried and true. Have fun, Guy At 03:50 PM 7/18/2004 -0700, you wrote: >I have never been 100% happy with any large-surface >veneering I have done ( always a little wavy ). But I >have used contact cement, then pounded on the surface >to get it glued "flat". And Elmer's glue, allowed to >dry, then ironed together. ( Plenty of heat/pressure! >) >In both cases a non-uniform glue layer seems to be the >main culprit in preventing flat resulkts, so use >aroller, spray can...whatever...to insure this! > I would certainly like to see a tech who has been >sucessful in creating a glass-flat re-veneering come >forth and share his/her secret!!! > Thump > > > >--- Andrew & Rebeca Anderson <anrebe@zianet.com> >wrote: > > I remember a syringe being used to remove air from a > > very persistent air > > bubble. 3 or 4" steel rollers work really well > > usually... > > Andrew > > At 07:59 PM 7/13/2004 -0700, you wrote: > > >I am working on an upright piano that had water > > damage on the horizontal > > >surfaces. I ordered thin walnut veneer and have > > been trying, > > >unsuccessfully, to get it to adhere to the boards. > > I did remove the old > > >damaged veneer, and cleaned and sanded the surfaces > > to be repaired. I > > >first worked with wood glue and clamped in a > > sandwich of boards, then > > >tried a contact cement on the next piece. I keep > > getting air bubbles. It > > >looks terrible! There has to be a secret to > > replacing veneer. Would one > > >of you expert refinishers give me the benefit of > > your knowledge...please? > > > > > >Ed Carwithen > > >John Day, OR > > > > > > >__________________________________ >Do you Yahoo!? >New and Improved Yahoo! Mail - Send 10MB messages! >http://promotions.yahoo.com/new_mail >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC