In a message dated 4/30/04 9:41:37 AM, Piannaman@aol.com writes: << It is in the very corner, where strut meets strut next to the stretcher. Hacksawing a slot may be difficult. I'm looking for advice as to the best way to get this out. >> If a grand, drive it through the bottom,(take care to brace all around the exit hole). If an upright, then drill the pin out,(get a couple of sizes of reverse thread drills and it will back out when you get it torn up enough). Then plug with 3/8" Falconwood plugs and redrill. This might be a $150 repair.... Good luck, this is a sticky procedure. Ed Foote RPT http://www.uk-piano.org/edfoote/index.html www.uk-piano.org/edfoote/well_tempered_piano.html
This PTG archive page provided courtesy of Moy Piano Service, LLC