This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Yes indeed you are right John. It has the plates that are loose - but = being that the secure the pins, does that not mean the pins are loose as = well? (ha, ha) As Richard pointed out, it looks like some have migrated = into the neighboring flange bushing - I've seen that before. Regarding pushing the pin back in - I've tried that, and I guess I have = knocked enough bushings out now that I tend to just repin it and not = worry about pushing the bushing out of the flange. Maybe your luck is = better? Terry Farrell ----- Original Message -----=20 From: John Ross=20 To: Pianotech=20 Sent: Saturday, September 13, 2003 11:53 AM Subject: Re: New Center Pin Design Hi Terry, This Yamaha, probably has the plates with a screw to hold the pin in = place. These screws should be snugged up, to stop the pin from wandering. It is not so much a loose pin that is causing the problem, it is the = loose plate. Sometimes the pins can just be pushed back in place with no damage, if = you loosen the plate a bit more. Then just tighten the screw. Problem solved without repining. Regards, John M. Ross Windsor, Nova Scotia, Canada jrpiano@win.eastlink.ca ----- Original Message -----=20 From: Farrell=20 To: Pianotech=20 Sent: Saturday, September 13, 2003 6:32 AM Subject: Re: New Center Pin Design That was actually the problem. When I first saw it I figured the guy = chewed up the flange bushings with this innovation, but I repinned it = with an 0.048" pin - so no enlargement there. The long unclipped end = interferring with the hammer shank wanting to return to the rest postion = is what caused the inoperable key. I could see that at least half of the = hammer flange center pins were walking out of their proper postition on = this piano - presumably I'll have a repinning and general action = refurbishing job on the piano. This particular piano was the worst = Yamaha I have ever tuned with respect to stray string noise (my = experience is that Yamahas are usually a pleasure to tune) - more like = tuning a Kimball console (false beats and unisons that would just not = come clean - I hate that). Terry Farrell ----- Original Message -----=20 From: Richard Brekne=20 To: Pianotech=20 Sent: Saturday, September 13, 2003 4:10 AM Subject: Re: New Center Pin Design Terry=20 you gotta love it... ... the fellow / gal was clever enough to = screw the darned thing out and put it in again.... but not clever enough = to snip off the leftover clip... wunerful...:)=20 Farrell wrote:=20 Great new center pin design. This (below) was recovered from a = 35-year old Yamaha console. One key didn't seem to be working....... I'm = all for improvising, but this is ridiculous! Terry Farrell --=20 Richard Brekne=20 RPT, N.P.T.F.=20 UiB, Bergen, Norway=20 mailto:rbrekne@broadpark.no=20 http://home.broadpark.no/~rbrekne/ricmain.html=20 http://www.hf.uib.no/grieg/personer/cv_RB.html=20 =20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/75/c4/e9/2b/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC