Tony, If I had been involved in the keytop replacement, or if the owner wanted to replace the sharps, yes, OK. However, I'm just the unlucky/unobservant guy trying to tidy up the last guy's mess with minimum fuss. Good to know about Vagias thickness. thanks Mike > [Original Message] > From: Tony Caught <caute@bigpond.com.au> > To: Pianotech <pianotech@ptg.org> > Date: 9/4/2003 3:03:32 PM > Subject: Re: too-thick keytops > > The new sharps are higher than the old sharps. One answer is to put on new > sharps at the same time as you use new key tops. > > Used a Vagus ? keytops on a piano the other day, they are thinner than some > and I was happy without planning the key tops. > > Tony > > > > > At 09:19 9/3/2003 -0400, you wrote: > > > Can't think of an easier way to get around your problem, anyone > else? > > > Mike Kurta > > >----- Original Message ----- > > >From: "Michael Spalding" <spalding48@earthlink.net> > > >To: "Pianotech" <pianotech@ptg.org> > > >Sent: Wednesday, September 03, 2003 8:22 AM > > >Subject: too-thick keytops > > > > > > > > I've seen cloth punchings which were trimmed. The oval pins kept them > from > > spinning. A good scissors or knife would do the trimming, but even faster > > would be a sharp chisel just outside the dent (or since the punchings are > > new, remove the white keys and use the sharps as chisel guides.) > > > > I've not tried it myself... just musing... > > YMMV > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC