The new sharps are higher than the old sharps. One answer is to put on new sharps at the same time as you use new key tops. Used a Vagus ? keytops on a piano the other day, they are thinner than some and I was happy without planning the key tops. Tony > At 09:19 9/3/2003 -0400, you wrote: > > Can't think of an easier way to get around your problem, anyone else? > > Mike Kurta > >----- Original Message ----- > >From: "Michael Spalding" <spalding48@earthlink.net> > >To: "Pianotech" <pianotech@ptg.org> > >Sent: Wednesday, September 03, 2003 8:22 AM > >Subject: too-thick keytops > > > > I've seen cloth punchings which were trimmed. The oval pins kept them from > spinning. A good scissors or knife would do the trimming, but even faster > would be a sharp chisel just outside the dent (or since the punchings are > new, remove the white keys and use the sharps as chisel guides.) > > I've not tried it myself... just musing... > YMMV
This PTG archive page provided courtesy of Moy Piano Service, LLC