---------------------- multipart/alternative attachment Does the New York Steinway specification of 5 1/8 " from hammer flange center pin to center of hammer molding apply to Hamburg as well? I am replacing hammers on a Hamburg D. The old (or present set of hammers) distance is 5 1/16 or a tiny bit more on all but one of the sample hammers (ends of sections). One is glued on at 5 1/8 (hammer #1) They probably use a mm. spec rather than inches.? Also, the new hammers I ordered from S&S specifically for the Hamburg sure are a lot wider and they are hornbeam instead of mahagony like the old ones. I will taper these to try to match weight. Your help is appreciated. Bob --------------------------------- Do you Yahoo!? Yahoo! SiteBuilder - Free, easy-to-use web site design software ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/87/6f/c1/b6/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC