If you are going to make/replace some of the Pallet Rods, those generally are 3/16" in diameter. They are available from SchaffAPSCO. If you do need 5/32" then take the 3/16" one and size them down. Make a sizing die out of a piece of 1/4" steel. Drill a 1/2" countersink on the backside, to the point that the point of the drill "Just" makes a dimple on the opposite side. Then flip it over and drill down, using the dimple to center on, with a 5/32" drill. Take the 3/16" dowels and drive them through the die with a wood mallet. Ta Da! <G> Best Regards, Joe Garrett, RPT, (Oregon) Been There, Didn't Like It, So I'm Here To Stay! [G}
This PTG archive page provided courtesy of Moy Piano Service, LLC