Kimball console - Schwander action - butt springs

[Tom Driscoll]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
 

 

-----Original Message-----
From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On
Behalf Of Robin Blankenship
Sent: Saturday, April 19, 2003 5:49 PM
To: pianotech@ptg.org
Subject: Kimball console - Schwander action - butt springs

 

Hi folks,

 

Does anyone have any quick, handy advice for replacing the hammer butt
springs on a Schwander vertical action? That is, how to feed the cord
through the tiny holes. 

 

Thanks,

Robin Blankenship

Southside Piano Service

Matoaca, VA

 


Robin,

                        Peel back the outer covering ,cut the "core"
back an inch , pull the covering back and C.A. glue the end . Trim to a
point and you will have made a Needle like end on your length of cord.
Thread them through and trim with a sharp razor blade. I hope this makes
sense. 

            Tom Driscoll RPT


---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/d7/4b/73/fa/attachment.htm

---------------------- multipart/alternative attachment--