Good memory Dale. I believe the one he made up was 24 inches long. I simply figured the longer it was, the more movement would be observed for a given MC change, so I made it twice as long. I simply edge glued a bunch of scrap from an old soundboard and sanded all the finish off. Terry Farrell ----- Original Message ----- From: <Erwinspiano@aol.com> To: <pianotech@ptg.org> Sent: Thursday, November 07, 2002 11:03 PM Subject: Re: Sitka EMC > In a message dated 11/7/2002 6:49:53 PM Pacific Standard Time, > mfarrel2@tampabay.rr.com writes: > Terry > 48 inches. Are you sure bout that?. I thought it was 3" or > 4"by 24" in the journal article. 48" would be hard to come up with. > Dale Erwin > > > > Terry wrote > > > > I am in the process of making a sitka spruce equilibrium moisture content > > (EMC) gauge as described by Nick Gravagne. Briefly, it is simply a 6 x > > 48-inch wide swath of soundboard panel with a thin rib or two on the back > > (ribs parallel to long axis and grain perpendicular to long axis). The > > gauge will indicate MC by the amount of curve in the panel. > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC