check the archives... David I. ----- Original message ----------------------------------------> From: <Tvak@aol.com> To: <pianotech@ptg.org> Received: Thu, 7 Nov 2002 23:18:51 EST Subject: pulley key repair kit >Just bought the pulley key repair kit from Schaff. Anybody have any >experiences with this, bad or good? >Looks basically like it would work. There's a drill bit to bore a recess >into the bottom of the key surrounding the elongated balance rail pin hole, >into which you insert a little wooden donut which has a proper sized hole. >I seem to recall reading about a method of sawing into the bottom of the key >on the elongated side of the hole and inserting a piece of veneer to resize >it... Whereas I'd probably screw that up, this seems do-able, even for a >klutz like me. >Any guidance is appreciated. I hesitate to proceed further for fear that I >might irreversibly ruin this plywood-soundboard/no serial #/no name spinet >piano. >Just practicing, >Tom Sivak >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC