I'm not really talking about a specific example. Each manufacturers parts have a slightly different profile and because of inconsistencies in Steinway manufacturing, usually one will fit the existing system better than another. I select knuckle to center based on the desired action ratio, or strike weight ratio, if you prefer. Knuckle diameters effect both convergence lines and friction. I prefer smaller knuckles when possible. David Love ----- Original Message ----- From: <Kdivad@AOL.COM> To: <pianotech@ptg.org> Sent: May 12, 2002 7:42 PM Subject: Re: Re: Steinway parts - whippen heel > In a message dated Sun, 12 May 2002 2:23:31 PM Eastern Daylight Time, "David Love" <davidlovepianos@earthlink.net> writes: > > >Whichever, the point was that it didn't quite fit correctly whereas another > >manufacturer's parts might have. > > > >David Love > > > David, are you sure you used the correct diameter knuckle and how about center pin to knuckle distance? I have not had the problem you pointed out and am not sure why you did. > > David Koelzer > DFW >
This PTG archive page provided courtesy of Moy Piano Service, LLC