> > What I want to know is at what point you can keep the bloomin thing from > flying out of there as its strung. My best success is to use a bit of > pressure from a pry bar and block to give it a good shove into position > before the chipping and tuning is attempted. > I've used the prior method before any strings go on but it seems the > pounding in of the pins makes them fall out routinely even if it's taped in > position. > Any body else? Oh yes. Duct tape beats masking tape, but... Are you using a pneumatic pin driver, or bouncing the piano around the shop with a big beater? It's tough to keep anything in place with the beater. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC