SAT II users

[Don Price]

John -   Thanks for that info.
-----Original Message-----
From: John Ross <piano.tech@ns.sympatico.ca>
To: pianotech@ptg.org <pianotech@ptg.org>
Date: Sunday, February 13, 2000 7:22 PM
Subject: Re: SAT II users


Hi Donald,
You did not need to cut off the plastic rivets, on the SAT. All you have to
do is, push the centre inside, and the rivet prise off with a small screw
driver.
Before the plug socket is replaced, collect the inserts, and on completion,
push in the rivets and insert the centres.
I have had to do it to replace a socket, and also when I replaced the
battery pack.
Regards,
John M. Ross
Windsor, Nova Scotia, Canada.
----- Original Message -----
From: "Don Price" <dcp2@rmi.net>
To: "Piano Tech List" <pianotech@ptg.org>
Sent: Sunday, February 13, 2000 3:24 PM
Subject: Re: SAT II users


> Terry -   I have an early SAT which has been upgraded with the FAC and
more
> memory.    I've had problems with the foot switch when the wires inside
the
> unit needed  to be resoldered.   I also had problems when the wire that
goes
> into the foot switch broke inside the insulation.   Probably due to being
> flexed too many times.   I also had a problem with the plug receiver
inside
> the SAT, which I discovered after I had ordered a new foot switch which
> didn't solve my problem .   Again a solder joint had released.   I cut the
> rubber "plugs" holding the cover on the SAT, and resoldered the joint
> myself.  I used a small electric soldering iron and heat sinks to isolate
> the heat on the joint I was repairing.    That's been at least two years
ago
> and it is still holding fine.  I used a seam of silicon glue along the
edge
> of the cover to hold in place.   The symptoms I had experienced were the
> unit shutting off, or not responding to the click of the foot switch.   I
> could jiggle the wire or plug and it might work O.K. again for 10 minutes,
> or the rest of the piano, depending on how I might have moved the SAT
> around.
>
> Donald C. Price, RPT
> 816 Vickie
> Ft. Morgan  CO  80701
> dcp@sosinc.net
> -----Original Message-----
> From: pianolover@worldspy.net <pianolover@worldspy.net>
> To: pianotech@ptg.org <pianotech@ptg.org>
> Date: Sunday, February 13, 2000 11:45 AM
> Subject: SAT II users
>
>
> Just out of curiousity, how many SAT (II) users are members of this list?
> Have you ever had trouble with either the "foot" or "thumb" switch? Also,
> the manual mentions a "LOWBAT" indication will be seen in the left window,
> when the battery is low, but that's not what I get; Instead, I get little
> black "dots" on either side of the note and/or octave indicators (left
> window).
>
> Terry Peterson
> LA, CA
>
>
> ______________________________________________________________
> Get free Internet service and email at http://www.worldspy.com
>
>
>